Question 1

How many OSHA inspections has ADOLFSON AND PETERSON, INC. had?

Accepted Answer

ADOLFSON AND PETERSON, INC. has been inspected 6 times by OSHA between Aug 4, 1982 and Aug 15, 1996, with 0 violations and $0 in penalties on record.

Question 2

How does Minnesota's state OSHA plan work?

Accepted Answer

Minnesota operates its own OSHA-approved state plan through Minnesota OSHA (MNOSHA), covering both private and public sector workers. MNOSHA conducts inspections and enforces standards at least as effective as federal OSHA.

Question 3

Why do some OSHA inspections result in zero penalties?

Accepted Answer

Not every OSHA inspection results in penalties. Inspections may find no violations, or the violations cited may be classified as Other-than-Serious with penalties reduced or waived. OSHA considers several factors when determining penalties, including employer size (small employers receive reductions), good faith efforts (having an effective safety program), and history (first-time offenders may receive lower penalties).

Question 4

How do OSHA complaint inspections work?

Accepted Answer

OSHA complaint inspections are initiated when a current employee, former employee, or their representative files a formal complaint about workplace hazards. OSHA is required by law to investigate all formal complaints. The agency may conduct an on-site inspection or, for less serious complaints, contact the employer by phone or letter to request corrective action. Workers who file complaints are protected from retaliation under the OSH Act.

Question 5

Can employees refuse to work if conditions are unsafe?

Accepted Answer

Under limited circumstances, employees may refuse to perform work if they reasonably believe they face an imminent danger of death or serious injury. Before refusing, the employee should ask the employer to correct the hazard and, if possible, contact OSHA. The conditions for a protected work refusal are narrow: the danger must be imminent, the employee must have asked the employer to fix it, and there must not have been time to get the hazard corrected through normal channels.

Question 6

What happens during the opening conference of an OSHA inspection?

Accepted Answer

At the start of an inspection, the OSHA compliance officer holds an opening conference with the employer. During this conference, the inspector presents credentials, explains the reason for the inspection (complaint, programmed, referral, etc.), describes the scope of the inspection, and outlines employer and employee rights. The employer may designate a representative to accompany the inspector during the walkaround. Employee representatives also have the right to participate.

ID	Opened	Type	Scope	Viol.	Penalties
#300360484	Aug 15, 1996	Complaint	Partial	0	$0
#120452560	Aug 11, 1994	Planned	Complete	0	$0
#104558309	Jul 21, 1987	Planned	Complete	0	$0
#2896405