Question 1

How many OSHA inspections has BUILT ROBOTICS had?

Accepted Answer

BUILT ROBOTICS has been inspected 1 times by OSHA between Mar 3, 2026 and Mar 3, 2026, with 0 violations and $0 in penalties on record.

Question 2

What forklift training does OSHA require for warehouse workers?

Accepted Answer

OSHA requires all powered industrial truck operators to receive training that includes formal instruction (lectures, videos, written materials), practical training (demonstrations and exercises), and evaluation of the operator's performance. Operators must be evaluated at least once every three years and must receive refresher training after an accident, near-miss, or observed unsafe operation. The training must be specific to the type of truck being operated and the conditions at the workplace.

Question 3

How does California's OSHA program differ from federal OSHA?

Accepted Answer

California operates Cal/OSHA (the Division of Occupational Safety and Health), an OSHA-approved state plan that covers both private and public sector workers. Cal/OSHA standards must be at least as effective as federal standards, and in many cases California has adopted more protective requirements. Cal/OSHA conducts its own inspections and sets its own penalty amounts, which may differ from federal OSHA.

Question 4

Why do some OSHA inspections result in zero penalties?

Accepted Answer

Not every OSHA inspection results in penalties. Inspections may find no violations, or the violations cited may be classified as Other-than-Serious with penalties reduced or waived. OSHA considers several factors when determining penalties, including employer size (small employers receive reductions), good faith efforts (having an effective safety program), and history (first-time offenders may receive lower penalties).

Question 5

What triggers an OSHA accident investigation?

Accepted Answer

In the DOL OSHA enforcement data, an accident inspection is an inspection record tied to a reported workplace incident. Employers must report any work-related fatality within 8 hours and any in-patient hospitalization, amputation, or loss of an eye within 24 hours. An accident inspection reflects that OSHA opened an inspection in response to an incident report, not that fault has already been determined.

Question 6

Can employees refuse to work if conditions are unsafe?

Accepted Answer

Under limited circumstances, employees may refuse to perform work if they reasonably believe they face an imminent danger of death or serious injury. Before refusing, the employee should ask the employer to correct the hazard and, if possible, contact OSHA. The conditions for a protected work refusal are narrow: the danger must be imminent, the employee must have asked the employer to fix it, and there must not have been time to get the hazard corrected through normal channels.

Question 7

What happens during the opening conference of an OSHA inspection?

Accepted Answer

At the start of an inspection, the OSHA compliance officer holds an opening conference with the employer. During this conference, the inspector presents credentials, explains the reason for the inspection (complaint, programmed, referral, etc.), describes the scope of the inspection, and outlines employer and employee rights. The employer may designate a representative to accompany the inspector during the walkaround. Employee representatives also have the right to participate.

BUILT ROBOTICS